| Woodworking Home Page | Next Item | Previous Item | Living Room | Plesums Home Page |
 |
This large art storage cabinet was built in three sections to be connected on-site in the Artist's studio - here they are still on the construction carts just outside our shop. The units on each end opened from the end; the center unit had two doors and opened from the front. |
To accommodate the different size paintings, each section was configured differently. The left section had no shelf, and was 38 inches wide to store large paintings. The middle section was 40 inches wide, had double doors and an adjustable shelf. The right section had an adjustable shelf about half the depth of the cabinet, so small paintings could be on the shelf, medium size below the shelf, and large in front of the shelf. The height of all units was about 53 inches. $1,900 for all three |
 |
A church education program for kids used seven sets of props for seven different training units. Each set of props were stored in a separate cabinet, that could be rolled to different parts of the room, or even to different rooms. But like most church facilities, the rooms were used by other groups, so the props needed to be covered - the bookcases had to be enclosed.
 |
Of the seven bookcases, six are of one size, and the seventh lower, deeper, and longer (hint: A creche is normally on top of this one). Each bookcase has a fixed shelf in the middle. The six bookcases are 42 inches long, 16 inches deep, and 30 inches high. The seventh is 48 inches long, 18 inches deep, and 25 1/2 inches high. |
Each of the bookcases has a removable panel installed on the front of the bookcase |
 |
 |
The front panel can be stored in a slot provided at the back of the bookcase. |
$350 for one, $650 for two
Additional units ordered at the same time, $250 each
Each bookcase was built from furniture grade 3/4 inch red oak plywood with a clear satin lacquer finish. The back is half inch plywood to provide stiffness to the bookcase as it is rolled, and to provide two finished sides... inside the bookcase and behind it. The front panel is 1/4 inch plywood with a solid oak strip as a handle and stiffener. The top overhangs the ends by about 3/16 inch, and has veneered edges. Four swivel casters hold the bookcase about 1 inch above the floor
Back to the woodworking page at www.plesums.com/wood
Back to the home page at www.plesums.com
Send e-mail comments to Charlie@Plesums.com
©2005 by Charles A. Plesums, Austin, Texas USA. ALL RIGHTS RESERVED.
We primarily serve Austin and the Central Texas area, but travel to the DFW area periodically and are glad to serve the Garland, Plano, Dallas, and other North Texas areas, and are willing to ship anywhere.